3.3 Mh Inductors for Main Board and E-field
#1

.jpg   E-field.jpg (Size: 815.76 KB / Downloads: 21) Folks, I am stumped.

Have both board soldered and ready to go, sands the inductors for the main board and the e-field antenna.

Where the heck am I supposed to attach the inductors , directly the L403 component, or to the THT components just below it.

The same on the E-field board  - there are two THT slots.  But the same bar on L1.  The holes do not seem to be right.

It is possible I am reading the instruction incorrectly.  But man I am stumped.


Attached Files
.jpg   Mainboard.jpg (Size: 835.65 KB / Downloads: 15)
Reply


Messages In This Thread
3.3 Mh Inductors for Main Board and E-field - by TheBigDon - 2021-07-30, 23:02

Forum Jump:


Users browsing this thread: 1 Guest(s)