2017-08-14, 01:25
Assembly instructions refer to a "point" on the Pin 1 corner of the filter chips. I see no discernible point.
Perhaps it is a terminology or translation issue.
What is a fool-proof way of making sure the filters are oriented to the board properly prior to soldering?
Is the picture in the instructions correct? Is the printing on the chips consistent? Can the printing be used as a key to orientation?
Thanks in advance... I want to get the filters and SMA connectors filled in, so I can get the box on the air!!!
Perhaps it is a terminology or translation issue.
What is a fool-proof way of making sure the filters are oriented to the board properly prior to soldering?
Is the picture in the instructions correct? Is the printing on the chips consistent? Can the printing be used as a key to orientation?
Thanks in advance... I want to get the filters and SMA connectors filled in, so I can get the box on the air!!!
Stations: 1961