Powering up puzzle

[MonkeeRench]

That should not happen if the switch is correctly connected.

The jumper should be removed from pins 5&6 and the switch will then connect them.

Note the pins with thicker red lines in lower left corner of the board layout.

http://www.blitzortung.org/Compendium/Ha..._3_brd.png

Thanks, Kevin, that worked like a charm!  I really appreciate this forum in filling in the blanks of documentation that somehow eludes me.  Another puzzle is on the layout of 19.3b which does not show the "Power" thru-holes where I connected the external switch discussed.