Blitzortung.org Forum › Public Forums › Hardware, Software, Lightning Physics v
Powering up puzzle

Linear Mode
Powering up puzzle
kevinmcc Offline
Participant
Posts: 366
Threads: 13
Joined: 2015-08-21
#2
2017-06-12, 23:03
That should not happen if the switch is correctly connected.

The jumper should be removed from pins 5&6 and the switch will then connect them.

Note the pins with thicker red lines in lower left corner of the board layout.

http://www.blitzortung.org/Compendium/Ha..._3_brd.png
Kevin McCormick KB0UOI
Macomb, IL USA
Stations: 1539
Reply


Messages In This Thread
Powering up puzzle - by MonkeeRench - 2017-06-12, 21:15
RE: Powering up puzzle - by kevinmcc - 2017-06-12, 23:03
RE: Powering up puzzle - by MonkeeRench - 2017-06-13, 15:51
RE: Powering up puzzle - by kevinmcc - 2017-06-14, 00:13
RE: Powering up puzzle - by MonkeeRench - 2017-06-14, 02:15
RE: Powering up puzzle - by kevinmcc - 2017-06-14, 05:03
RE: Powering up puzzle - by DelandeC - 2017-06-14, 08:42
RE: Powering up puzzle - by allsorts - 2017-06-14, 10:03
RE: Powering up puzzle - by kevinmcc - 2017-06-14, 23:12
RE: Powering up puzzle - by BobW - 2017-06-15, 04:11
RE: Powering up puzzle - by cutty - 2017-06-15, 05:38
RE: Powering up puzzle - by allsorts - 2017-06-15, 16:20
RE: Powering up puzzle - by kevinmcc - 2017-06-16, 22:57
RE: Powering up puzzle - by BobW - 2017-06-15, 12:05
RE: Powering up puzzle - by allsorts - 2017-06-15, 18:18
RE: Powering up puzzle - by Jon Point - 2017-06-16, 01:11
RE: Powering up puzzle - by allsorts - 2017-06-17, 22:39

Possibly Related Threads…
Thread Author Replies Views Last Post
  Solar Powering with Power bank GilbertKE 3 19,356 2018-11-14, 15:05
Last Post: MrB

Forum Jump:


Users browsing this thread: 2 Guest(s)