2016-09-27, 06:06
I can confirm R825 is unpopulated on my System Blue (PCB 19.3).
When you apply power, the LEDs should illuminate in this sequence (with Power always on):
1. Mode, Network, GPS (with a low beep)
2. Fault, Alarm
3. Mode, Network (if connected), Fault
4. A high beep will sound when fault turns off again.
Have a go at following the DFuSe firmware update procedure in the assembly instructions, hopefully that fixes it
When you apply power, the LEDs should illuminate in this sequence (with Power always on):
1. Mode, Network, GPS (with a low beep)
2. Fault, Alarm
3. Mode, Network (if connected), Fault
4. A high beep will sound when fault turns off again.
Have a go at following the DFuSe firmware update procedure in the assembly instructions, hopefully that fixes it
Stations: 1614