+- Blitzortung.org Forum (https://forum.blitzortung.org)
+-- Forum: Public Forums (https://forum.blitzortung.org/forumdisplay.php?fid=29)
+--- Forum: General Discussion (https://forum.blitzortung.org/forumdisplay.php?fid=31)
+--- Thread: Red EField Boards (/showthread.php?tid=4097)
Red EField Boards - davidmc36 - 2025-07-16
Is there any way to get the files for PCB 13 and 14? I would like to get some made. I see places that will make boards and do the SMD part.
Seems a lot of the files are purged from BO database.
TIA
D
RE: Red EField Boards - davidmc36 - 2025-07-25
Ooooookaaaaayyyyy.
So it seems I stumbled on the .brd and .sch files.
I guess nobody dropped by who knew the location.
The next question is, there must be some programming to be loaded onto the Atmega.
How would that happen?
If I got the boards built, will I be able to use them?
I see info about firmware for the STM32.
I was looking at a place that would make small batch boards and install the SMD components. Pricey im sure but i would really like to have the E Field. I have built a few projects like this supplied with board and SMD and I do the through hole.
RE: Red EField Boards - davidmc36 - 2025-07-26
(2025-07-25, 21:19)davidmc36 Wrote: ...So the STM32 takes care of it on start-up?
The next question is, there must be some programming to be loaded onto the Atmega.
How would that happen?....
"5.5.3 Start-up Sequence
After a reset or power-on, the controller initializes itself and peripherals, like CPU-Clocks, LCD,
Real-Time-Clock, I/Os, Amplifiers and USARTs. "
RE: Red EField Boards - davidmc36 - 2025-07-26
(2025-07-25, 21:19)davidmc36 Wrote: ... small batch boards and install the SMD components. Pricey im sure but .....Not that outrageous actually for 5 to 20 boards.
Is anybody interested if I got some made???
D