An interesting article!


http://journals.ametsoc.org/doi/10.1175/...14-00193.1

http://journals.ametsoc.org/doi/pdf/10.1...14-00193.1


/Egon

Hi,
I assembled the station, System Blue, firmware 8.2_Blue, but GPS reports: Availability: 100% Type: Unknown, 115200 baud rate. Did not get valid data from GPS for ... (Debug log: Buffer overrun - Didn't receive GGA/RMC sentence)
In addition I can't see Station Id and User ID. They are both "0".
What should I do?

Thank you in advance

Steela85

Hi guys,
i have red, my station is 1127 and in screen i see this message: vin too low

And in my webpage i see this message: Interference Mode (Burst) in Tracker.

I have FW 8.2 PCB 10.4/12.3

In map my station appear at red color, active / no reception.

Any idea what is problem?



Thanks guys.
Kind regards,

Hi everybody,

Since a couple of days my System Blue, PCB 19.3, locks up sometimes and it is making a constant chirping/whining noise.
The noise seems to be coming from the three large coils near the power LED.

Is this normal?

update: I swapped the usb power supply. the old one was generating 4.00V, the new one, 4,96V. The sound is less noisy, but still present... I downgraded to fw 8.2, from 8.3b2 too...

Hi

When I open the link provided on station UI I get the following error

Internal Server Error :: Code 500

Are there any other ways to register the station? Is it something temporary and will be fixed soon?

When I open the link provided on station UI I get the following error

Internal Server Error :: Code 500

Are there any other ways to register the station?

Hi

Last night I finally got around assembling the System RED that has been sitting on my shelf for a very long time now. (Really sorry about that. Reason: children)

The Atmega8's are off the shelf (not kit ones) and I'm guessing that they have to be programmed but I cannot find any information about this in the documentation or in the forum?

Hi guys I have some problem with my system blue. 
In admin control panel I have this message :
You need to Save to Flash and Reboot to take effect some of the new settings! 
If I click on save button and reboot,  the system has the same message. 
I have the 8.2 firmware. 
Another problem is that the System blue often emits a long beep and the LAN LED disappears. 
I have to turn it off and on again to unlock it.
Can you help me?
Thanks in advance

excuse for my bad English

Hi folks
Is there somewhere a detailled manual/description available for the controller interface (Blue system)? 
Examples: What is meant by Error "Overflow"   or what does the parameter "HP on" flag in the amplifier section mean   ?
Thanks for any clearing up hints.

I have system blue pcb 19.3

Is there any guidance on the order of gains? 

2x32 is the same as 32x2 but I suspect there may be a preferred order? 

Like wise 1x16 or 4x4? 

Thanks